There are several Facebook groups dedicated to specific types of antenna. However for now, just looking at those “get started” choices, here are links to wiki pages each of the popular antennas types mentioned above: It is then connected to a low noise amplifier (LNA), which is powered through a bias tee. The active element consists of a thin copper sheet (or copper foil) in the shape of a wedge which is rolled into a cylinder around a plastic sheet. ADSB antennas for 1090MHz, Inmarsat antennas for 1.6GHz, special 137MHz antennas for NOAA satellite reception and so on as well as the traditional yagi antennas with directional properties. The dressler ARA-2000 The article shows how to build the antenna from scratch. The key pros and cons are shown in the table below:įor dedicated reception of a narrow band of specific frequencies there’s a whole host of specialist options (e.g. The “long wire” (more correctly named as the “random wire” antenna) and the whip antennas are the lowest cost options but have some limitations which is why the more expensive active magnetic loop and discone options have become popular. The picture above shows the four most popular choices of antenna for covering the bulk of the spectrum offered by wideband SDR receivers like the SDRplay RSP family. However it is possible to cover most of it with just 2 or 3 antennas. That’s a lot of spectrum and no single antenna will give good performance over the entire frequency range. With any of the RSP family you have the possibility of receiving signals anywhere from 1kHz all the way up to 2GHz. We’re working on adding web-based suggestions, eventually with links to recommended antenna manufacturers. Newcomers to the radio hobby, are often at a loss as to where to start when it comes to choice of antennas for their SDR receiver.
0 Comments
Leave a Reply. |